t-case gear broken

Anything related to 4WDs and 4WDing

Moderator: Committee

Post Reply
jonfromhamilton
Posts: 1238
Joined: Sun 29 Jan, 2012 8:23 pm

t-case gear broken

Post by jonfromhamilton »

so my front input shaft on my transfer case has about a third of the teeth stripped off it
any idea as to what would cause this? everything else in the box seems fine
User avatar
gwagensteve
Financial Member
Posts: 2163
Joined: Mon 13 Aug, 2007 5:20 pm

Re: t-case gear broken

Post by gwagensteve »

I assume you mean the input shaft, not the front output.

This is the smallest gear in the transfer therefore it's always the one that fails.

No idea on cause, without doing expensive failure analysis you might never know if it was a material or heat treatment problem. Whose gears?

Steve.
michaelpiranha2000 wrote: The rear is in great condition. but has a broken crown wheel and pinon
jonfromhamilton
Posts: 1238
Joined: Sun 29 Jan, 2012 8:23 pm

Re: t-case gear broken

Post by jonfromhamilton »

Trail Tough gears 6.4s
Do you think it is more likely to be a fault in the gear or another factor like abuse or installation errors?
I'm pretty sure all the bearings were done when I put them in the case to begin with.
Post Reply