Hi Fellas.
I have been trying to think of ways to use 10mm key steel to get oil in my diff. Its making my brain hurt.
Jonfromhamilton (Hi Kiwi) wrote. "I even have some 10mm key steel for getting oil in my diffs"
Can someone please explain this to me.
Regards. Wayne.
10mm Key Steel
Moderator: Committee
- gwagensteve
- Financial Member
- Posts: 2163
- Joined: Mon 13 Aug, 2007 5:20 pm
Re: 10mm Key Steel
push/tap/hammer the key steel into the 10mm square drive fill plug. Then you can put a spanner/shifter/(even a socket if you have an appropriately sized 12 point socket) and undo it - Key steel is just chosen because it's stronger and has sharper corners than 10mm square bar.
michaelpiranha2000 wrote: The rear is in great condition. but has a broken crown wheel and pinon
Re: 10mm Key Steel
Hi Fellas.
Thanks Steve.
Something learned.
Regards. Wayne.
Thanks Steve.
Something learned.
Regards. Wayne.
-
- Posts: 1238
- Joined: Sun 29 Jan, 2012 8:23 pm
Re: 10mm Key Steel
and ur 3/8 drive ratchet will eventually fuck the plug
Re: 10mm Key Steel
That one had me thinking also
- christover1
- Financial Member
- Posts: 3046
- Joined: Thu 09 Aug, 2007 5:18 pm
- Location: Croydon Victoria Australia
- Contact:
Re: 10mm Key Steel
I used fill plugs from something else, can't remember from what, but had a spanner end instead of the square hole. I remember having some hex head type as well, which were better than square
ZOOKS RULE DA BUSH