Page 1 of 1
EGR pipe block off g16b efi in sj50 sierra
Posted: Sun 06 Nov, 2016 8:23 pm
by BZOOK
Hi all. The EGR steel pipe is 5mm from one of the main brake master cylinder lines. I busted the brake line during engine swap. Can I block off inlet and outlet for the EGR pipe? If I can't then will need to route it differently or get creative. Thanks.
Re: EGR pipe block off g16b efi in sj50 sierra
Posted: Wed 09 Nov, 2016 3:07 pm
by BZOOK
Hi. Would a pic help? I'm tempted to attach the pipe again and try to massage it out the way.
Re: EGR pipe block off g16b efi in sj50 sierra
Posted: Wed 09 Nov, 2016 6:01 pm
by lbzook
Maybe a pic might help, you shouldnt need to delete it to fit the engine in.
Re: EGR pipe block off g16b efi in sj50 sierra
Posted: Wed 09 Nov, 2016 6:23 pm
by BZOOK
http://s1160.photobucket.com/user/brent ... brary/g16b
The brake line as it was in the Sierra, hits the pipe. Red tape was a temp stop leak.
Re: EGR pipe block off g16b efi in sj50 sierra
Posted: Mon 14 Nov, 2016 10:39 am
by BZOOK
Hello. In chatting with our good friends at zook parts I now know that I have a late model g16b hence the uncommon issue. I've decided to reattach the pipe for the EGR and 'persuade' it a little to clear the brake line.
Re: EGR pipe block off g16b efi in sj50 sierra
Posted: Thu 17 Nov, 2016 5:45 am
by lbzook
Looks like you should be able to get it far enough out of the way. Just make sure you clearance enough to allow for engine movement too.