Page 1 of 1
price estimate on hubs etc?
Posted: Mon 25 Nov, 2013 10:25 pm
by jonfromhamilton
I have some hubs lined up with spindles and calipers etc, everything from the steering knuckle out but I haven't talked price with the guy yet.
Anyone want to offer some advice on a reasonable price I should be paying for them (both sides) ??
Re: price estimate on hubs etc?
Posted: Wed 27 Nov, 2013 3:51 pm
by jonfromhamilton
C'mooooooon
Re: price estimate on hubs etc?
Posted: Wed 27 Nov, 2013 6:11 pm
by jono165
I reckon around $50 a side would be reasonable. Might need to factor in new bearings/seals too.
Re: price estimate on hubs etc?
Posted: Wed 27 Nov, 2013 7:46 pm
by Greg
Add up the centre rd price list to get an idea I reckon
Re: price estimate on hubs etc?
Posted: Wed 27 Nov, 2013 8:37 pm
by gwagensteve
I reckon somewhere between there and $150 for the lot.
Steve.
Re: price estimate on hubs etc?
Posted: Wed 27 Nov, 2013 9:46 pm
by jonfromhamilton
Thanks guys
I was not really sure, the dude said 300!! and it has been out in a paddock
do you use the term paddock in Australia?
anyway it would cost a lot to get the setup I want in brand new trailer parts so I will be willing to be flexible a bit but not towards $300 n oways when the trailer budget is set at around 600 bucks all up.
Thanks for your input
Re: price estimate on hubs etc?
Posted: Wed 27 Nov, 2013 10:48 pm
by Matthew
If the spindles and hubs from the GV are any use to you they're yours in exchange for helping me move the GV out of Chris's garage and onto the street.