I'm thinking of putting in a 1.6 Vitara carby engine..

[UZI4U]

Hey guys

I can get my hands on a 1.6 carby engine from rocker cover to sump without any bolt ons e.g manifolds, carby etc.

WIll the bolt ons from my 1.3 carby motor fit straight on to a 1.6 carby motor?

I was hoping that it would be a straight forward easy swap.

Please let me know if there is anything I should be aware of.

Lachlan

[dank]

The 1.3 head will bolt onto the 1.6 block. Problems sorted! You will need an adaptor kit for the gearbox and engine mounts from BenT off auszookers for $200 bucks. Worth doing if you can get it cheap. I'd run a gasket kit through the block before you put it in, always hear of people blowing rear mains and cam shaft seals not long after rebuilds.

[greyghost]

Yes your manifolds will fit onto the 1.6 if it's an 8 valve
This will be eazier than swapping heads