Page 2 of 5
Re: 11th May- tech day
Posted: Sun 14 Apr, 2013 8:51 pm
by martin
Sounds like a good day, I am in
Re: 11th May- tech day
Posted: Mon 15 Apr, 2013 2:09 pm
by Brad.Jones
Not sure if this could be something that we could look at:
http://i129.photobucket.com/albums/p237 ... ver1/6.jpg
I would like to do this to my GV.
Re: 11th May- tech day
Posted: Mon 15 Apr, 2013 2:39 pm
by christover1
I'm planning to be there, barring unforseen circumstances.
Happy for you to look, question and ridicule
I did the cutting and measuring, and pros did the turning and welding stuff,
but Stevie knows welding tech.
Re: 11th May- tech day
Posted: Mon 15 Apr, 2013 2:42 pm
by Brad.Jones
What exactly do I need to do it??? Just a second passenger side driveshaft.
Re: 11th May- tech day
Posted: Mon 15 Apr, 2013 2:59 pm
by christover1
Brad.Jones wrote:What exactly do I need to do it??? Just a second passenger side driveshaft.
Need a 3 bolt flange from the passenger side, its cut from the inner shaft.
And the bit/cup thingy that goes into diff from drivers side.
Cup bit is cut/turned down and the flange bit is welded to it.
Re: 11th May- tech day
Posted: Mon 15 Apr, 2013 10:56 pm
by Jonno
I have some vitara axles if you are chasing them? Not sure which ones you need though
Re: 11th May- tech day
Posted: Sun 21 Apr, 2013 11:50 am
by Richardnclark
Steve, I'm in also. Richard
Re: 11th May- tech day Please confirm attendance
Posted: Wed 24 Apr, 2013 6:53 pm
by gwagensteve
Can anybody/everybody who wants to come (and there were heaps of hands at the club meeting) please confirm on here so I can get the catering volumes sorted.
Steve.
Re: 11th May- tech day -PLEASE CONFIRM ATTENDANCE HERE
Posted: Wed 24 Apr, 2013 7:09 pm
by luigi
Hi Steve. I have work already booked for that morning. But my last job is in Panton Hills. I won't get there till about midday. Hope that's OK.
Regards. Wayne.
Re: 11th May- tech day -PLEASE CONFIRM ATTENDANCE HERE
Posted: Wed 24 Apr, 2013 8:02 pm
by gwagensteve
That's fine Wayne.
