Mods and Repairs afternoon - Sunday 18th November
Moderator: Committee
-
- Posts: 20
- Joined: Wed 14 Nov, 2018 3:32 am
Re: Mods and Repairs afternoon - Sunday 18th November
What was the total time it took to do the whole job ?
Re: Mods and Repairs afternoon - Sunday 18th November
This is such a good idea. Who's next? A few decent builds in the works. Surely a group effort could be beneficial.
-
- Posts: 1238
- Joined: Sun 29 Jan, 2012 8:23 pm
Re: Mods and Repairs afternoon - Sunday 18th November
Steve125 j20 conversion. should only take an afternoon
- christover1
- Financial Member
- Posts: 3046
- Joined: Thu 09 Aug, 2007 5:18 pm
- Location: Croydon Victoria Australia
- Contact:
Re: Mods and Repairs afternoon - Sunday 18th November
They had started before I got there at 12:30pm.
He drove home just after dark, so roughly 8pm.
This included a lunch break, snack breaks, lemonade breaks, and a bbq tea break.
ZOOKS RULE DA BUSH
-
- Posts: 20
- Joined: Wed 14 Nov, 2018 3:32 am
Re: Mods and Repairs afternoon - Sunday 18th November
Thanks for the reply Chris, lol that’s a pretty good effort pulling an engine and replacing it in just over 8 hours lol
I like the idea of a working bee on the zooks through the club ... sounds like it’s a pretty tight bunch of guys, can’t wait to meet yous all at the next meeting
I like the idea of a working bee on the zooks through the club ... sounds like it’s a pretty tight bunch of guys, can’t wait to meet yous all at the next meeting
Re: Mods and Repairs afternoon - Sunday 18th November
Hi guys, what are your tips and tricks for getting the main crank pulley bolt undone?
- christover1
- Financial Member
- Posts: 3046
- Joined: Thu 09 Aug, 2007 5:18 pm
- Location: Croydon Victoria Australia
- Contact:
Re: Mods and Repairs afternoon - Sunday 18th November
My solutions are never right way to do anything.
But I used to jam something through the inspection hole to lock flywheel.
Then use a bar on the spanner.
I'm sure there is other dodgy ways, too.
Rattle gun may not fit in there?
I'll do a random internet search
But I used to jam something through the inspection hole to lock flywheel.
Then use a bar on the spanner.
I'm sure there is other dodgy ways, too.
Rattle gun may not fit in there?
I'll do a random internet search
ZOOKS RULE DA BUSH
-
- Posts: 1238
- Joined: Sun 29 Jan, 2012 8:23 pm
Re: Mods and Repairs afternoon - Sunday 18th November
i made up a bar that bolted to the pulley holes and it stopped it turning then used a breaker bar on the main crank
-
- Posts: 1238
- Joined: Sun 29 Jan, 2012 8:23 pm
Re: Mods and Repairs afternoon - Sunday 18th November
ill b home sunday if u need a hand
- christover1
- Financial Member
- Posts: 3046
- Joined: Thu 09 Aug, 2007 5:18 pm
- Location: Croydon Victoria Australia
- Contact: